| Issue |
Korean Journal of Chemical Engineering
|
| 3041-3047 |
Effect of drying methods on removal of residual solvents from solvent-induced amorphous paclitaxel Choi MG, Kim JH |
| 3048-3053 |
Analysis of air blast effect for explosives in a large scale detonation Kwon HE, Tak KJ, Maken S, Kim HS, Park JS, Moon I |
| 3054-3066 |
Vulnerability assessment index at process-level for the identification of adaptive strategies in wastewater treatment plants under climate change KiM DW, Jacome G, Lee SC, Moya W, Nam Kj, Yoo CY |
| 3067-3076 |
Constraint handling optimal PI control of open-loop unstable process: Analytical approach Tchamna R, Lee MY |
| 3077-3084 |
Effects of organic and inorganic metal salts on thermogravimetric pyrolysis of biomass components Zhao S, Liu M, Zhao L, Lu J |
| 3085-3091 |
CO and CO2 methanation over Ni catalysts supported on alumina with different crystalline phases Le TA, Kim TW, Lee SH, Park ED |
| 3092-3101 |
A reaction kinetic study of CO2 gasification of petroleum coke, coals and mixture Kook JW, Gwak IS, Gwak YR, Seo MW, Lee SH |
| 3102-3110 |
Multilateral approaches for investigation of particle stickiness of coal ash at low temperature fouling conditions Namkung H, Kim HT, Wang F, Lin K, Yu G |
| 3111-3118 |
Compositional and structural variations of bitumen and its interactions with mineral matters during Huadian oil shale pyrolysis Chang Z, Chu M, Zhang C, Bai S, Lin H, Ma L |
| 3119-3124 |
Investigating the effect of nano-silica on efficiency of the foam in enhanced oil recovery Amirsadat SA, Moradi B, Hezave AZ, Najimi S, Farsangi MH |
| 3125-3131 |
A comparison of fluidized bed pyrolysis of oil sand from Utah, USA, and Alberta, Canada Shun DW, Shin JS, Bae DH, Ryu HJ, Park JH |
| 3132-3141 |
Deep desulfurization of model oil by photocatalytic air oxidation and adsorption using Ti(1.x)MxO2 (M=Zr, Ce) Zhang W, Li X, Wang H, Song YJ, Zhang S, Li C |
| 3142-3149 |
Efficiency evaluation of the photocatalytic degradation of zinc oxide nanoparticles immobilized on modified zeolites in the removal of styrene vapor from air Rangkooy HA, Pour MN, Dehaghi BF |
| 3150-3155 |
Effects and optimization of initial pH and sewage sludge compost content on leaching of lead and zinc in contaminated soil Eom DS, Ahn JH |
| 3156-3162 |
Anti-melanogenic effect of Prunus davidiana extract in melan-a melanocyte through regulation of OCA-2, TRP-1 and tyrosinase Singh BK, Morya VK, Lee HB, Kim JS, Kim EK |
| 3163-3169 |
Introduction of alkali soaking and microwave drying processes to improve agar quality of Gracilaria verrucosa Kim YW, Shin HJ |
| 3170-3177 |
Preparation of mesh-reinforced cellulose acetate forward osmosis membrane with very low surface roughness Mirkhalili SM, Mousavi SA, Abadi ARS, Sadeghi M |
| 3178-3184 |
Effect of support layer on gas permeation properties of composite polymeric membranes Afshoun HR, Chenar MP, Ismail AF, Matsuura T |
| 3185-3194 |
Preparation and characterization of a porous silicate material from silica fume Zhang Y, Qi H, Li Y, Zhang Y, Sun J |
| 3195-3199 |
Spherical graphene and Si nanoparticle composite particles for high-performance lithium batteries Lee JH, Moon JH |
| 3200-3207 |
Plasmon-enhanced ZnO nanorod/Au NPs/Cu2O structure solar cells: Effects and limitations Yoo IH, Kalanur SS, Eom K, Ahn B, Cho IS, Yu HK, Jeon HT, Seo HT |
| 3208-3213 |
Feasibility study on the differentiation between engineered and natural nanoparticles based on the elemental ratios Kim WC, Yeom CJ, Lee HJ, Sung HK, Jo EH, Eom IC, Kim YH |
| 3214-3219 |
Expanding depletion region via doping: Zn-doped Cu2O buffer layer in Cu2O photocathodes for photoelectrochemical water splitting Lee KH, Lee CH, Cheong JY, Lee SK, Kim ID, Joh HI, Lee DC |
| 3220-3225 |
Preparation of WO3, BiVO4 and reduced graphene oxide composite thin films and their photoelectrochemical performance Yoon SH, Park DW, Kim KS |
